White Card (CPCCWHS1001) Exam Questions & Answers 2026 (11–20)

Question 1

A 'residual risk' is best described as:

TheoryPractice · Accepted Answer

The risk that remains after controls have been applied. Residual risk is what remains after implementing control measures; it should be as low as reasonably practicable.

Question 2

Who is primarily responsible for identifying and managing hazards on a construction site?

TheoryPractice · Accepted Answer

Everyone on site, including workers and management. WHS legislation places shared duties on all persons—workers, supervisors, and management.

Question 3

What does 'ALARP' stand for in WHS risk management?

TheoryPractice · Accepted Answer

As Low As Reasonably Practicable. ALARP means risks must be reduced to a level as low as reasonably practicable given cost and practicality.

Question 4

Which of the following best describes a 'near miss'?

TheoryPractice · Accepted Answer

An unplanned event that did not result in injury but had the potential to do so. Near misses are important warning signs and must be reported to prevent future incidents.

Question 5

When using a ladder, which risk is classified as a 'working at heights' hazard?

TheoryPractice · Accepted Answer

Falling from the ladder. Falls from ladders are a working-at-heights hazard requiring appropriate controls.

Question 6

What is the purpose of a site safety induction?

TheoryPractice · Accepted Answer

To inform workers about site-specific hazards, rules, and emergency procedures. Site inductions ensure every worker understands the hazards, controls, and emergency procedures specific to that site.

Question 7

A Risk Priority Number (RPN) combines which two factors?

TheoryPractice · Accepted Answer

Likelihood of occurrence and severity of consequence. Risk is the product of likelihood and consequence (severity), used to prioritise controls.

Question 8

Which colour is universally used on construction sites to indicate 'danger – do not use'?

TheoryPractice · Accepted Answer

Red. Red is the danger colour; red tags on equipment mean it is out of service and must not be used.

Question 9

What is the main purpose of a toolbox talk (safety meeting)?

TheoryPractice · Accepted Answer

To brief workers on daily hazards and safe work practices before starting tasks. Toolbox talks keep hazard awareness high by reviewing daily risks and safe procedures before work begins.

Question 10

If you are unsure whether a task is safe to perform, you should:

TheoryPractice · Accepted Answer

Stop work and seek clarification from a supervisor before proceeding. If in doubt, stop. WHS law gives workers the right to cease unsafe work until it is made safe.

White Card (CPCCWHS1001) Exam Questions & Answers 2026 (11–20)

More White Card (CPCCWHS1001) practice questions

Free practice here. Timed mocks when you are ready.